Firmly bite the strip, no need to peel back the silicon cover.
Assemble wire by yourself as needed, flexible to different project! No need to solder. Just clasp your prepared led strip section into the connector to get connected. Be made of flame retardant material, safely use.
Type: H Type 1 Pin, H Type 2 Pin, T Type 1 Pin, T Type 2 Pin
Rated Voltage: <300V
Rated Current: <10A
Housing Temperature: <135°C
Exogenous Cold-resistant: -45 °C
Working Environment: Moisture-proof Ventilation Environment -20 °C ~ 80 °C
“G” for AWG <0.75㎡~0.50㎡ outside diameter < Φ 2.1
“D” for AWG <0.50㎡~0.32㎡ outside diameter < Φ 2.1
5/10 x Single LED Connectors(Please choose the quantity, thank you!)
Wire End Connection:
1. Cut the desired wire length and insert it directly into the guide slot.
2. Make sure that the positive & negative on the strip light surface are corresponding to the ones on the wires.
3. Close the transparent cap with a plier until it is fully seated on both sides of the bottom base.
4. End of installation.
There are no inquiries yet.